TKR MANUFACTURING (MALAYSIA) SDN. BHD.
Lot 11, Kawasan Perindustrian Tangga Batu, 76400 Melaka, Malaysia.
TEL:60-6-3516050
FAX:60-6-3515557
Company Registration No:198801007083 (174441-P)
・From Kuala Lumpur International Airport
Approximately 1 hour 30 minutes by car ride
・From Singapore International Airport
About 3 hours by car ride on land route ~ departing Singapore ~ entering Malaysia
・TKR designed power supply module / electric component unit assembly for air-conditioners (Electrical Assembly Division)
・Assembly of car audio, car amplifier (OEM/TKR design model), Switching power supply, etc.
・Unit assembly of OA equipment and units such as DVD, BD mechanical decks
・Injection molding processing for gear precision parts, chassis, trays, etc.
Features and main product items
・Substrate packaging components: 0402 microchip supported / 0.3 mm Fine pitch parts supported / Flexible for BGA, deformed parts, special parts, etc. / Thorough prevention of leakage by appearance inspection equipment
High density packaging boardsPower supply moduleSmall chip component packaging board
・Electrical Assembly Division: TKR headquarters can flexibly deal with development and design according to customer requirement specifications / Acquisition of IATF 16949 certification has enabled production of genuine automotive parts. / consistent quality control system from parts acceptance inspection established/ flexibly supporting multi-product small lot production
Time domain speakerInverter control boardSteering control unit
・Air Conditioner Assembly Division: Power supply module can be designed and developed by our own company / Integrated production system from pressing, molding, to substrate packaging / Consistent quality control from parts acceptance inspection / Flexibly supporting multi-product small lot production
Power supply module by TKR designAssembly of electric unit for air conditioner
・Resin Mold Division: High cycle molding (180 tons/20 seconds or less) Short injection molding time based on flow analysis during creation of mold / Can handle from 30 tons for small items to 350 tons for large items / Quick response to modification of molds by design change of customer side
Molded parts for DVD/BD mechanical unitsMolded parts for inverter control board
・Mechanical assembly unit: Flexible production support possible for order quantity, item changes/ Shortened injection molding time based on flow analysis / Flexible formation of line by operator's multi-functionalization / Integrated production by in-house production of press and mold parts / High quality management system utilizing the know-how of complete production assembly
Molded parts for DVD/BD mechanical unitsDot printer